Craftsman Bandsaw - Twist & Lock Rip Fence Assembly-Model 113 series

Description

All pictures provide the best description, best details and shows how the rip fence is
mounted. Determine from these pictures that your Craftsman Bandsaw is "setup" or
equipped the same as my pictures show to accept this rip fence accessory !
Before bidding review all of the pictures and [compare the construction] of your 12 inch Craftsman
Bandsaw table or worksurface construction, so you can determine if this accessory will fit !
Notice pictures number 4, 5, 6 and 7 to see how the "rear of the rip fence assembly" fastens to the "Z"
shaped metal angle bracket on your Craftsman Bandsaw table.
At the rear of the rip fence assembly there is a (rounded metal clip) that fits over the "Z" shaped metal
bracket to hold the rip fence in position. This rounded metal clip is shown on my No. 1 picture of the fence assembly.
Your Bandsaw must have the "Z" shaped metal bracket for this accessory to fasten to.
Sales Only in the USA,    ( Except not in Alaska or Hawaii )
*** No International Sales, No International Shipping ***
Thank you for looking !