Hand Electric Drill Drive Self-Priming Pump Oil Fluid Water Small Transfer Pumps

Description

index 4
Product Features:
1. To achieve optimum priming and long service life, apply a few drops of lubricating oil in pump inlet prior to each use and flush with clean water after each use
2. Be sure inlet hose is airtight and as short as possible, inlet hose should not exceed 9FT(2.75m)
3. When pumping abrasive fluids or liquids with solids, using a strainer on the inlet line for longer service time
4. It is recommended that the pump is mounted to a surface for security and ease of use
5. Mount and start drill, observe whether the inlet pipe has a certain fluid that is sucked into the pump within 15-20 seconds. If not, check that inlet tube is properly mounted to inlet pump. Do not run dry, if pump fails to prime, check if the hose is kinked or clogged
6.The recommended speed is 1500-3500 rpm. The pump head and flow are related to the speed. The higher the speed, the higher the head and flow
-1500 rpm, the pump head is about 1.5 meters, the flow is about 15L per minute.
-3000 rpm, the pump head is about 3 meters, and the flow rate is about 30L per minute.
7.Pumping speed is fast, can pump 25-30 L water per minute(depends on the rpm of drill)
Product Specification:
Color: black
Size: Approx. 106*37*64mm
Material: Plastic
Net Weight: Approx. 218g
Inner Tube Diameter: Approx. 15mm
Transmission Shaft Diameter: 8mm Round Shank
Working Temperature: Approx. 5-49℃(41-120℉)
Package Include:
1*Drill Pump
2*Hose Clamp
2*Connector
* Any problems pls contact us at any time before leaving a negative/neutral feedback. Many thanks to you.
Copyright © 2017 - Epoweroutlet. All rights reserved.
Shop
Newsletter
Contact Us