One (1) REINFORCED CRAFTSMAN 113 model Table Saw Crank Handle Wheel part 806872

Description

Your purchase is for one (and only one) handle.
NOTE - Because these handles are prone to cracking, I've reinforced them using expoxy glue and a copper ring.  These should last a long time!  Much more durable this way.
If you prefer a stock part (without the reinforcement), visit my
online shop
for even more handles and table saw part options!
Part number 806872 - also works as a replacement for part
62689
Will fit any Craftsman 10" model 113.XXXXXX with a 1/2" flat sided shaft.
Will
not
fit Craftsman 315.XXXXXX series saws, they have a 12MM shaft (smaller), also may
not
fit Craftsman 113.xxxxxx 8" or 9" models, please check shaft size.
Some of the main reasons that your handles crack are as follows: lack of lubrication on internal parts, corrosion on internal parts, not releasing the angle lock down handle before trying to change the angle of the blade. over turning the handle at the end of travel.